Obviously there's no logical place for a line break with just one word, so it asks you where you want that break. This, however, depends on some settings, so as a last resort, the scripts opens this GUI: If it can't find a grammatically suitable place, the line break goes in the middle of the line. If the length ratio is too high, it doesn't use that line break and tries something else. After each attempted line break, the script checks the length of the two parts. (The line normally breaks after "when".)īefore: the place you belong is the place where people are waiting for you.Īfter: the place you belong is the place \Nwhere people are waiting for you. In this case, it finds a conjunction that's roughly in the middle of the line and thus is a good place to start the second "line", so the break goes before "when". You have a comma there too, but the script sees that the length of the two parts would be extremely disproportionate, so it looks for another solution. If you care about where line breaks are, you obviously want it after that comma, and that's what you get, in this case very easily, by pressing a hotkey.īefore: However, one must exercise caution when synchronizing with the other side.Īfter: However, one must exercise caution \Nwhen synchronizing with the other side. This line breaks naturally after the second "there". īefore: Beyond that sky over there, there are people waiting for you.Īfter: Beyond that sky over there, \Nthere are people waiting for you. The primary places for line breaks are after punctuation marks, namely. Where it gets inserted is a result of rather exptensive and complex mechanisms, so I will only explain part of them. If it doesn't, the script will insert a line break. If your line has any line breaks, the script will remove them all. dialogue), but it's useful for typesetters too. Supports: Properly only English language (Rules for others will be significantly simplified) Underline and Strikeout is probably useless, but it was really trivial to add.ĭownload Line Breaker Purpose: Use a hotkey to insert a line break at the estimated most appropriate place in the line * This explanation is for Italics, but it works the same for Bold. This correction system only checks the first already existing italics tag and doesn't check \r, so not everything gets "corrected". In other words, since the style here was italics, the first tag became \i0, and thus the second one had to be \i1. The other tags, however, don't change in this case, because the script corrects a wrong sequence at the beginning, that is two consecutive italics tags with the same value. If the style is italics, though, you will get this:īecause the style is italics, the first tag becomes \i0. If the style is in italics and there is no \i tag, you'll get \i0, not \i1.įor every italics tag in the line, it switches to the other one (1 vs 0). This reads values from style and goes through all italics tags in the line. Supports: Handling of all subsequent inline tagsĪ script for hotkeying that applies italics* to your line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |